DSP Setup Examples

Example-1: Simple setup using the ProFX plugins:

Wave 0/1, ASIO 0/1 will playback straight to your Analog Rear Output Jack.
Wave 2/3, ASIO 2/3, kX Synth will playback straight to your Analog Front Output Jack.
Line-In Records here straight into any standard WINMME audio application.


(Note 1: Doubleclicking on SRC and K1LT or K2LT will open their dialog..duh..)
(Note 2: In the above setup, The ProFX I/O plugins are "wired" directly to each other without any other plugin between them.
Due to the ProFX's nature this particulair setup *can* lead to unpredictable behaviour although this is rarely reported.
Max. M ( kX's no.1 DSP guru) has written an in-depth explanation on "naked I/O DSP registers" for those who are interrested.)

Example-2: Setup as a stand-alone Guitar FX-Box

This is a good example to show you that the DSP can bypass the Computer entirely and works completly by itself
as a stand-alone device once initiated.
Here the DSP is setup to act as a typical Electric Guitar FX-Box. The guitar is plugged (via some preamp) into the Line-In jack.
A renamed [Src] plugin is used to feed the Line-In Signal into the DSP, followed by a Noise Gate, a Fuzz, a Flanger and a Speaker Simulator.
The Lowpass's output goes to a Reverb and a Mixer to provide a Dry/Wet Reverb Mix.
The Mixer's output is then fed to [kxlt] where it exits the DSP chip into the D/A converter and finaly to one of your speaker outputs.

Note that there isn't any audio signal going into your computer here at all..!
The guitar signal goes into the soundcard, straight through the DSP setup, out of the soundcard into your speakers.
You don't have to run any Audio application. Once this DSP setup is loaded, it will keep doing it's job in "Real time"
untill you switch off your computer or load another DSP setup.

Next time the same setup,but with the ability to record the guitar while playing back some audio track.

(New DSP example setups will be added in the feature.)

/LeMury